Indirect Solar system ITS

Residential buildings

The ITS is fitted with 2 coils. In the solar alignment the upper coil is connected to a water heater or boiler. This water heater or boiler
provides the pre- or after heating if the solar contribution is not
sufficient. The lower coil of the ITS transfers the heat from the collectors. This indirect solar system has a high comfort level because the water heater or boiler as well as the collectors transfer the heat to the ITS.

An ITS solar system is a very suitable application in residential and small commercial properties. This system will provide the needed hot water in a very energy efficient manner.

The house on the pictures is fitted with an ITS 300 solar system with 3 collectors. The Smart Display shows the temperature in the collector, the temperature of the water in ITS and, if combined with an output sensor, the solar contribution. The Smart Display and the output sensor are available as accessories.



Products used in this solution


New superstore at Bradford

A.O. Smith has supplied a range of equipment to meet hot water demand at ASDA’s brand new 38,000 square-foot store in Lidget …

Football Stadium

Saint Mirren Football Club (commonly known by the shorter St. Mirren or by the nicknames; The Buddies and The Saints) is a …

Centenary Pavilion Exhibition Centre

The Centenary Pavilion is the new exhibition and conference centre at Elland Road in Leeds (home of Leeds United football club), and …

Several High schools

The A.O. Smith solar systems are very suitable for use in high schools. Besides the intelligent solar installation these systems are often …